Toro Groundsmaster 3280-D Service Manual page 339

Removing the Pneumatic Seat Suspension
Installing the Pneumatic Seat Suspension
Groundsmaster ® 3280-D/3320
05138SL Rev B
g224018
1. Pneumatic suspension
assembly
1. Park the machine on a level surface, lower the cutting deck (or implement),
shut off the engine, set the parking brake, and remove the key from the
key switch.
Do not damage the electrical harness when removing the seat
suspension from the machine.
2. Remove the seat and seat suspension from the machine; refer to
Seat (page 7–19).
3. Remove the pneumatic seat suspension components as necessary
188 and Figure 189).
1. Install the pneumatic seat suspension components
189). Refer to Figure 188
Do not damage the electrical harness when installing the seat
suspension to the machine.
2. Install the seat and seat suspension to the machine; refer to
(page 7–19). Ensure to connect the harness electrical connector to the
seat switch.
Figure 189
2. Flange-head screw (4
each)
IMPORTANT
for fastener torque values for assembly purposes.
IMPORTANT
Page 7–25
3. Lower seat bracket (2
each)
Operator
(Figure
(Figure 188 and Figure
Operator Seat
Chassis: Service and Repairs