Blower Fan - Toro Groundsmaster 3280-D Service Manual

Blower Fan

g243780
1. Rivet (19 each)
2. Mixing box cover
3. Cover insulation
Removing the Blower Fan
Operator Cab: Service and Repairs
4. Air diverter assembly
5. Mixing box
6. Tap screw (6 each)
Note: The blower fan can be removed and installed with the mixing box (item 5
in Figure 314) attached to the cab headliner.
1. Park the machine on a level surface, lower the cutting deck, shut of the
engine, set the parking brake, and remove the key from the key switch.
2. Remove the roof from the top of the cab to get access to the blower fan; refer
to Removing the Roof Assembly (page
3. For assembly purposes, label the heater hoses. Loosen the hose clamps
and disconnect both the heater hoses from the tubes on the heater core.
4. Remove the mixing box cover as follows:
A. Carefully use a small prybar to raise the head of the pin in the center of
each rivet that secures the mixing box cover.
B. Lift the rivets from the cover and mixing box.
Figure 314
11–4).
Page 11–12
7. Blower fan
8. Heater core assembly
Groundsmaster
05138SL Rev B
® 3280-D/3320