Toro Groundsmaster 3280-D Service Manual page 341

Removing the Lift Arms
Groundsmaster ® 3280-D/3320
05138SL Rev B
g224019
1. Lift arm (left)
2. Flange bushing (2 each)
3. Grease fitting (2 each)
g224020
1. Inner roll pin split
2. outer roll pin split
1. Park the machine on a level surface, lower the cutting deck (or implement),
shut off the engine, set the parking brake, and remove the key from the
key switch.
2. Remove the cutting deck from the lift arm; refer to the Cutting Unit Operator's
Manual.
3. Disconnect the brake return spring from the lift arm.
4. Remove the lift arm components from the machine
5. If necessary, disassemble the lift arm
Figure 191
4. Rivet (3 each)
5. Plastic pad
6. Rubber pad
Figure 192
3. Roll pin ends flush with pivot pin surface
(Figure
Page 7–27
7. Plain washer (3 each)
8. Spherical bearing
9. Retaining ring
(Figure 190).
191).
Chassis: Service and Repairs