Steering Cylinder (4-Wheel Drive) - Toro Groundsmaster 3280-D Service Manual

Steering Cylinder (4-Wheel Drive)

g225055
1. Thrust washer
2. Jam nut
3. Rear axle pin
4. 90° grease fitting
5. Washer-head screw
6. Ball joint (2 each)
7. Steering cylinder
Removing the Steering Cylinder (4-Wheel Drive)
Groundsmaster ® 3280-D/3320
05138SL Rev B
8. Retaining ring (2 each)
9. Grease fitting
10. 45° hydraulic fitting
11. Hydraulic hose
12. Hydraulic hose
13. O-ring (2 each)
14. O-ring (2 each)
1. Park the machine on a level surface, lower the cutting deck (or implement),
shut off the engine, set the parking brake, and remove the key from the
key switch.
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
Figure 100
15.
16.
17.
18.
19.
20.
21.
5–77).
Page 5–123
90° hydraulic fitting
45° lube fitting
Steering cylinder support bracket
Bolt (4 each)
Washer (4 each)
Jam nut (4 each)
Rear axle (4-wheel drive)
Hydraulic System: Service and Repairs