Toro Groundsmaster 3280-D Service Manual page 307

Removing the PTO Electric Clutch (continued)
Installing the PTO Electric Clutch
Groundsmaster ® 3280-D/3320
05138SL Rev B
3. Remove the PTO belt from the clutch and PTO shaft pulley; refer to the
Traction Unit Operator's Manual.
4. Remove the clutch stop components
Note: Hold the coupler on the front of the engine to prevent crankshaft from
turning when removing the bolt that secures the clutch to the stub shaft.
5. Remove the bolt and spacer that secure the clutch to the stub shaft.
Note: It may be necessary to lower the rear frame and axle assembly to
allow clutch removal; refer to
(page 7–9).
6. Slide the clutch from the stub shaft. Locate and retrieve the square key.
1. Apply anti-seize lubricant to the stub shaft.
2. Position the square key in the stub shaft. Slide the clutch onto the stub shaft
and ensure to engage the clutch stop.
Note: Hold the coupler on the front of the engine to prevent crankshaft from
turning when installing the bolt that secures the clutch to the stub shaft.
3. Apply Loctite #242 (or equivalent) to the threads of the bolt. Secure the
clutch to the stub shaft with the spacer and bolt.
4. Install the clutch stop components
is tight against the clutch flange.
5. Check alignment between the clutch pulley and the PTO shaft pulley; refer to
Aligning the PTO Pulley to the Electric Clutch Pulley (page
6. Install the PTO belt to the clutch and PTO shaft pulley, and adjust PTO belt
tension; refer to the Traction Unit Operator's Manual.
7. Connect the clutch to the machine wire harness.
(Figure 175
Removing the Rear Frame and Axle Assembly
(Figure 175). Ensure that the clutch stop
Page 6–79
or Figure 176).
9–11).
Electrical System: Service and Repairs