Toro Groundsmaster 3280-D Service Manual page 83

Installing the Engine (continued)
Groundsmaster ® 3280-D/3320
05138SL Rev B
Ensure that the clutch pulley and PTO pulley are aligned during PTO
shaft installation.
16. Install the PTO shaft to the machine; refer to
9–9).
17. Position the fan shroud to the radiator. Ensure that a minimum of 6.4 mm
(0.25 inch) clearance exists at all points between the shroud and the fan.
Secure the fan shroud to the radiator with the 4 fasteners, 6 flat washers,
and 4 locknuts (Figure
18. Install the coolant reservoir assembly to the bracket on the radiator fan
shroud (Figure 29). Install the reservoir hose to the radiator fill opening and
secure with the hose clamp.
19. Add coolant to the radiator; refer to the Operator's Manual.
20. Position the battery base to the brackets and secure with the 3 bolts (item
12 in Figure 28) and 3 flange nuts.
21. Install the battery to the machine; refer to
22. Connect both the battery cables to the battery. Connect the positive battery
cable and then the negative battery cable.
23. Ensure that all the wires, fuel lines, hydraulic hoses, and cables are clear of
moving parts and secured to their original locations.
24. Check the engine-oil level and adjust as necessary; refer to the Operator's
Manual.
25. Prime the fuel system; refer to
26. Start the engine and operate the hydraulic controls to properly fill the
hydraulic and engine coolant systems; refer to
System (page 5–85)
27. Lower the hood and secure it with the latches.
IMPORTANT
29).
Servicing the Battery (page
Priming the Fuel System (page
and refer to proper coolant fill procedure.
Page 4–27
Installing the PTO Shaft (page
4–16).
Charging the Hydraulic
Diesel Engine: Service and Repairs
6–80).