Toro Groundsmaster 3280-D Service Manual page 73

Removing the Fuel Tank (continued)
Installing the Fuel Tank
Groundsmaster ® 3280-D/3320
05138SL Rev B
g221627
1. Flange nut
2. Flange-head screw
3. Console
9. Remove the flange-head screws and flange nut that secure the lower control
panel to the machine
10. Remove the locknut (item 25 in
11. Use a fuel transfer pump to remove the fuel from the fuel tank and into
a suitable container.
12. Loosen the hose clamps and carefully disconnect the fuel hoses from the
standpipe and elbow fittings (items 30 and 29 in
the fuel tank.
Note: Before removing the fuel hoses from the tank fittings, label the hoses
for assembly purposes.
13. Cover or plug the fuel hoses or fitting openings to prevent contamination
from entering the fuel system.
14. Remove the fuel tank as shown in
1. Install the fuel tank to the frame
2. Connect the fuel hoses to the standpipe and elbow fittings (items 30 and
29 in Figure 26) on the top of the fuel tank. Secure the fuel hoses with the
hose clamps.
3. Secure the lower control panel to the machine with the flange-head screws
and flange nuts (Figure
4. Secure the tank to the left fender with a locknut (item 25 in
5. Position the control panel to the fuel tank, connect the wire harness to the
panel components, and secure the panel to the machine with the 4 thumb
screws.
6. Install the seat plate to the machine.
7. Install the seat suspension and seat to the machine; refer to
(page 7–19).
Figure 27
4. Washer-head screw (2
each)
5. Flange-head screw (3
each)
6. Throttle control
(Figure 27).
Figure 26) from the left fender.
Figure 26.
(Figure 26).
27).
Page 4–17
7. Locknut (2 each)
Figure 26) on the top of
Figure 26).
Operator Seat
Diesel Engine: Service and Repairs