Agilent Technologies 1260 User Manual page 73

5 Make these entries for the instrument:
6 Click OK.
7 Leave Edit BootP Addresses by pressing Close.
8 Exit BootP Settings by pressing OK.
9 After each modification of the BootP settings (i.e. EditBootPSettings) a stop
10 Power cycle the Instrument.
11 Use the PING utility to verify connectivity by opening a command window
Agilent 1260 Infinity DAD and MWD User Manual
• MAC address
• Host name, Enter a Hostname of your choice.
The Host Name must begin with "alpha" characters (i.e. LC1260)
• IP address
• Comment (optional)
• Subnet mask
• Gateway address (optional)
The configuration information entered is saved in the Tab File.
or start of the BootP service is required for the BootP service to accept
changes. See "Stopping the Agilent BootP Service"
the Agilent BootP Service"
OR
If you changed the IP address, power cycle the instrument for the changes
to take effect.
and typing:
Ping 10.1.1.101 for example.
The Tab File is located at
C:\Documents and Settings\All Users\Application Data\Agilent\BootP\TabFile
Automatic Configuration with BootP
on page 75.
LAN Configuration
on page 74 or "Restarting
4
73