Merlin 3070 Service And Maintenance Manual page 241

6.
Slide the module into the slot until the latch at the bottom of the module
catches at the base of the slot. With one hand, press firmly at the front
of the module while using the other hand to snap the latch into place.
7. The five front panel jacks accept 4-pair modular cords, which are used
to connect the jacks on the module with the appropriate jacks in the jack
field. System wiring is used between the jack field and the telephones.
Refer to the Installation Guide: Models 1030 and 3070 for details.
To connect basic telephones to the module once it has been installed, refer
to the Installation Guide: Models 1030 and 3070.
NOTE: If you have any difficulties, remove the 5-Basic Telephone Module
and check the connectors at the back of the module and at the back of the
slot. Check for bent pins or other damage that prevents the connectors from
matching properly. If you find any damaged pins, contact your equipment
supplier.
1.
To remove the module from the control unit or Expansion Unit, discon-
nect modular cords from the 5-Basic Telephone Module and press down
firmly on the latch at the base of the module until it releases. Slowly slide
the module out of its slot in the unit.
Removal
AT&T
Information Systems
Issue 1
Copyright © 1984 AT&T
Printed in the U.S.A.