Merlin 3070 Service And Maintenance Manual page 216

Installation
1.
Determine the wall type for mounting the standards: plywood, sheetrock,
or masonry.
Find a spot on the wall where at least one of the stanards will be screw-
2.
ed into a stud and which meets the positioning and environmental re-
quirements stated in the Installation Guide: Models 1030 and 3070.
3. Determine whether your standards have four holes or six holes.
NOTE: For the 4-hole standards, the two holes spaced 10 inches apart must
be at the bottom of the standard. For the 6-hole standards, the hole that
is 1 inch from the end of the standard must be at the bottom.
Align a standard straight down the center of one of the wood slats. Us-
4.
ing a 3/16" drill bit, drill a
of the standard.
NOTE: Drill all four holes for the
drill the top hole, the third hole,
Drill
all 4
holes
hole through the wood slat at the top hole
4-hole standards. For the 6-hole standards,
and the fifth and six holes. (See Figure 2).
4-Hole
Standard
Figure 2.
Holes to be Drilled in Standards
Drill
these
4 holes
6-Hole
Standard