Mounting the Control Unit
Remove the Power Module from the control unit cabinet, by pressing
1.
down firmly on the latch at the base of the module until it releases.
Slowly slide the module out of its slot in the control unit.
Remove the rightmost faceplate from the cabinet by pressing down on
2.
the rib at the top of the faceplate with the tip of a screwdriver and pull-
ing out on the faceplate (Figure 6).
Set the control unit cabinet on the brackets so that the metal front stif-
3.
fener rests on the rubber cushions (Figure 7).
Metal
Front
Stiffener
Figure 6.
Removing Faceplate from Control Unit
Shelf
Rests
Figure 7.
Mounting the Control Unit on the Brackets
Faceplate