Merlin 3070 Service And Maintenance Manual page 113

(201A) 10-BUTTON VOICE TERMINAL WALL MOUNT (32001)
This bracket is used to mount 7103 or
7303 Voice Terminals on a wall surface.
INSTALLATION INSTRUCTIONS
Note: Be sure to select a location for
intallation at least as large as
the voice terminal; the 201A
Wall Mounting is slightly smaller
than the terminal itself.
Select the wall mounting location: using
1.
the wall mount as a template, mark
the four mounting hole locations (two
upper slots and two lower holes). See
Figure 1.
VOICE TERMINAL
MOUNTING SLOTS
MOUNTING
Figure 1
2. Select proper toggler for wall thickness
or wall type:
For walls 3/8- to 1/2-inch thick,
select the smaller of the two sizes
provided.
For walls 5/8- to 3/4-inch thick,
select the larger of the two sizes
provided.
For solid walls, either of the two
sizes may be used.
Drill four holes at the four toggler
3.
mounting locations, using a 5/16-inch
diameter drill.
4. Fold toggler (see Figure 2A).
5. Insert a toggler in each of the mount-
ing locations, and tap each toggler
flush to wall (see Figure 2B).
Pop the anchor open with the red key
6.
— do not hammer the key (see Figure
2C).
7. Insert and partly thread the top two
screws into the starter holes of the
togglers (see Figure 2D).
8.
Position the two upper mounting slots
onto the screws and slightly tighten
(see Figure 2E).
9. Insert the two remaining screws into
the lower mounting holes (see Figure
2E).
Tighten all four screws securely.
10.
A
C
RED KEY
WALL MOUNT
E
UPPER
MOUNTING
SLOTS
11. Convert the 10-Button Voice Terminal
from a desk terminal to a wall-
mounted terminal by following the
substeps below:
LOWER
Remove the desk stand.
Remove the number card retainer
HOLES
and the number card (see Figures
3 and 4).
Remove the screw under the num-
ber card and lift out the handset
retainer from the upper housing.
(see Figure 5).
Rotate the handset retainer 180
degrees end-over-end (see Figure
6).
Replace the handset retainer into
upper housing. If properly inserted,
a portion of the handset retainer
should be projecting into the
handset well of the upper housing
(see Figure 7).
Replace screw.
Replace number card and number
card retainer.
SWITCHHOOK
BUTTON
NUMBER
STRIP
RETAINER
B
D
WALL
MOUNT
MOUNTING
SLOTS
TWO LOWER
MOUNTING
HOLES
Figure 2
PAPER CLIP
Figure 3
NUMBER STRIP
(EXAMPLE)
Figure 4
HANDSET
RETAINER
HANDSET
RETAINER
SCREW
Figure 5
HANDSET
RETAINER
REMOVED
ROTATE
TO WALL
MOUNT
POSITION
Figure 6
HANDSET
RETAINER
HANDSET
ROTATION
RETAINER
IN WALL
MOUNT
POSITION
HANDSET
RETAINER
SCREW
Figure 7
12. Thread one end of the D8W Modular
Cord up through the cord slot in the
wall mount, and plug the cord into the
jack labeled "LINE" on the back of the
voice terminal (see Figure 8).
CIB 2856
3
HANDSET
RETAINER
SCREW
REMOVED
AFTER
HANDSET
RETAINER
SCREW