Merlin 3070 Service And Maintenance Manual page 137

(7305 H02) 34-BUTTON DELUXE VOICE TERMINAL (3166)
The 34-Button Deluxe Voice Terminal (Fig-
ure 1) provides access to intercom and
outside lines, and to programmable and
other button features which may be pro-
vided in your communcations system.
HANDSET
INDICATOR LIGHTS
SPEAKER
Figure 1
ASSEMBLING YOUR VOICE
TERMINAL
Unpack voice terminal and coiled hand-
set cord.
2.
Turn voice terminal upside down and
plug one end of handset cord into jack
with the drawing of the handset beside
it (see Figure 2).
Warning: Do not plug the handset
cord into the jacks labeled
"LINE" or "OTHER".
REMOVE TO PLUG IN
HANDS-FREE UNIT OR
OTHER ACCESSORY
"OTHER"
JACK
HANDSET
VOICE
CORD
TERMINAL
(BOTTOM
VIEW)
Figure 2
Turn the voice terminal right side up.
3.
4. Plug the loose end of the handset cord
into the handset (see Figure 2).
Position the voice terminal on the desk
5.
stand or wall mount.
To convert the voice terminal from a
6.
desk terminal to a wall-mounted termi-
nal, follow the instructions packed with
the wall mount (CIB 2887).
SPEAKER/RINGING AND TEST
CONTROL
Test/Program (T/P) Control
The T/P switch is located on the left side
of the voice terminal (see Figure 3). It has
three positions: T (spring loaded and must
be held in the T position), center (indicated
by a "dot"), and the P position. It is set to
the center position for normal operation of
the voice terminal. After connection to the
control unit, the voice terminal can be put
into the test mode by holding the switch in
the T position to test the lights and ringer
(all red and green lights will flash and the
set will ring if it is working properly). The
voice terminal can be put into the program
mode by placing the switch in the P posi-
tion.
Speaker/Ring Volume Control
The volume control is located on the left
side of the voice terminal (see Figure 3).
Sliding the switch away from you increases
the volume while sliding it toward you de-
creases the volume.
Note:
" L I N E "
TEST/PROGRAM
JACK
SWITCH
HANDSET
T
TOP P
VIEW
The volume control changes the
volume of alerting rings, speaker,
and button clicks.
SPEAKER/RING
VOLUME CONTROL
TOP
VIEW
Figure 3
REMOVING AND REPLACING
LABELS
Removal
Above the touch-sensitive buttons,
1.
grasp the silver tab and pull the label
out of the label slot (see Figure 4).
2.
Labels may now be typed or handwrit-
ten in pencil or ink and can be erased
(if necessary).
Replacing
1. Insert the bottom of the label into the
label slot above each column of the
touch-sensitive buttons.
2. Slide the label all the way into the slot
until the desired typed label appears
next to the proper button. (Note that
the label slides into the slot and behind
a thin top graphics overlay.)
Figure 4
Equipment manufactured by AT&T Technologies in the U.S.A.
CIB 3000