Merlin 3070 Service And Maintenance Manual page 128

10. Convert the 5-Button Voice Terminal
from a desk terminal to a wall-
mounted terminal by following these
steps:
Remove the number card retainer
and the number card (see Figure
6).
Remove the screw under the num-
ber card and lift out the handset
retainer from the upper housing
(see Figure 7).
Rotate the handset retainer 180
degrees end-over-end (see Figure
8).
Replace the handset retainer into
the upper housing. If properly in-
serted, a portion of the handset
retainer should be projecting into
the handset well of the upper
housing (see Figure 9).
Replace screw.
Replace number card and number
card retainer.
SWITCHHOOK
BUTTON
NUMBER
STRIP
RETAINER
PAPER CLIP
Figure 6
HANDSET
RETAINER
HANDSET
RETAINER
SCREW
Figure 7
HANDSET
RETAINER
REMOVED
ROTATE
TO WALL
MOUNT
POSITION
Figure 8
HANDSET
RETAINER
SCREW
Thread one end of the D8W Modular
11.
Terminal Cord up through the cord
slot of the wall mount, and plug into
the jack labeled "LINE" on the back
of the voice terminal.
Position the back (or bottom) of the
12.
voice terminal so the mounting slots
of the voice terminal fit just above the
wall mount's mounting tabs.
13. Gently slide the voice terminal down
so the voice terminal tabs fit securely
in the three mounting slots (see Fig-
ure 10). Forward pressure must be
applied to the voice terminal so the
terminal's locking tab is depressed.
HANDSET
RETAINER
SCREW
REMOVED
Equipment manufactured by AT&T Technologies in the U.S.A.
HANDSET
HANDSET
RETAINER RETAINER
IN WALL AFTER
MOUNT ROTATION
POSITION
HANDSET
RETAINER
SCREW
Figure 9
Figure 10
Instructions For
14A 5-Button Voice
Terminal Fixed Desk Stand
and Wall Mount (32000)
CIB 2885
ISSUE 2
Copyright © 1984 AT&T Technologies
All rights reserved