Merlin 3070 Service And Maintenance Manual page 219

11. Install the shelf rests onto the end of the brackets:
For the 4-hole standards, insert the four rubber cushions into the
holes on the shelf rests. Align the holes on the bottom of a shelf
rest with the hole at the end of a bracket and attach the shelf rest
with one of the small self-tapping screws (Figure 5). Repeat with
the other shelf rest.
For the 6-hole standards, the rubber cushions are already in place.
Insert the small rectangular tab on a shelf rest into the hole on
the end of a bracket. Turn the shelf rest in a clockwise direction
until the clip on the bottom of the shelf rest latches onto the sides
of the bracket (Figure 5). Repeat with the the other shelf rest.
12. Insert the metal tabs on the end of the brackets into the slots in the
standards so that when the control unit is set on them, it will be ap-
proximately 4 feet from the floor. Tap down lightly on the brackets with
a hammer until the tabs are locked firmly into place.
Shelf Rest
Bracket for
4-Hole Standard
Shelf Rest
Bracket for
6-Hole Standard
Figure 5.
Attaching a Shelf Rest to a Bracket