BOMBARDIER ELAN 3042 1985 Shop Manual page 87

5,13, Oil seal P.T.O. side & oil seal magneto
side
At seal installation. apply a light coat of lithium grease
on inside diameter lip of seals .
For bear1ngs lubrication purpose. a gap of 1.0 mm !040"1
must be maintained between seals and bearings. When
installing pla1n seals (without locating ring or without spa-
cing legsl. ensure to maintain the spec1fled gap as illus-
trated.
1 mm
I 040"1
A.009002004
2,18,19, Upper crankcase, lower crankcase
& loctite
Crankcase halves are factory matched and therefore. are
not interchangeable as single halves.
Pnor to JOining of crankcase halves. spray some new
injection oil on all the mov1ng parts of the crankshaft.
0
NOTE: Prior to apply Loctite
515
it is possible to
use primer N (PIN 413 7053 001 or primer NF WIN
413 7024 001 It increases cure speed and gap filling ca-
pability . Refer to supplier instructions
Position the crankcase halves together and tighten nuts
(or bolts) by hand then install armature plate (tighten)
on magneto side to correctly align the crankcase halves.
Torque bolts to proper torque following illustrated
sequence.
Section 02 ENGINE
Sub-section 04 (447 ENGINE TYPE)
Follow sequence shown .
9 N•m 180 lbf•inl
3
All the other bolts
are torque to 21 N•m 115 ibf•ft!
A009002005
21,26, Screw M8 x 45 & M8 x 70
The bigger screws have to be torque to 21 N•m (15
lbf•ftl .
28, Screw M6 x 40
The smaller screws have to be torque to 9 N•m (80
lbf•inl
To install magneto, refer to "Magneto" 1n this section.
02-04·9