BOMBARDIER ELAN 3042 1985 Shop Manual page 400

...
Section 05 SUSPENSION
Sub-section 01 (BOGIE WHEELS)
7. Wheel suppon
Z Spring
3 Lock washer !cross shaft!
4. Cap screw !cross shafr.J
5
Cross shaft
6. Grease cap
7.
Nut !flange!
REMOVAL
Raise and block rear of vehicle off the ground.
Re lease tra ck tension by unlocking the l1 nk plate springs
using an appropriate tool .
A00200 5001
3,4, 5, Lock washers, cap screws & cross
shafts
Starting at ce nter bogie wheel set, remove bolts and lock
washers secunng cro ss shaft to frame.
0
NOTE :
To prevent the cross shaft from rotating
within the cross support. wedge a screwdnver blade
between th e cross shaft and cross support.
A002 005001
Remove bogie wheel set .
05-01-2
8 Inner flange
9
Bearmg
70 Wheel [Ire
7 7 Outer flange
72.
Bolt /flange!
7 3. Grease fitting
7 4 . Elastic band iA ip ineJ
0
NOTE:
Since spring diameter may vary depending
upon actual installat ion location, 11 is important to
identify th e 1nstalla tion of each bogie wheel set. Observe
this position when reinstalling sets.
Repeat operation for remaining bogie wheel se ts.
DISASSEMBLY & ASSEMBLY
1, Wheel support
Heat spring anchor on wheel support before attempting
to open or close anchor.
5, Cross shafts
Clean then lubrica te cross shaft w1th low temperature
grease (P /N 413
7044 00 1
before installation .
1,9, Wheel support & bearing
Always pull or push bea ring by inner race . When installing
bearing on wheel support, position beanng shield towards
inner flange, then press down until bearing is sitt ing flush
with support end. Then notch 13 notches) wheel support
with a cold chisel to secure the bearing in place.
Bear~ng
shield
on this side
A002005003
7,12, Flanges nuts
&
bolts
Bogie wheels are factory riveted . When separation is
necessary, remove rivets secunng wheel tire and flanges
by using a
3116"
dia. drill. Secure flanges and tire using