BOMBARDIER ELAN 3042 1985 Shop Manual page 477

- - - - - - - - - - - - - - - -
Damaged area have to be sanded 25 mm 11 ")to 35 mm
(1
1'2")
all around ustng 180 gnt sand paper
Check surface for proper smoothness.
Us1ng chloronated solvent, remove any dirt or oil spills
from the inside area then sand or scuff with 80 grit sand
paper at least 50 mm 12" l all around damaged area on
the 1nside surface. Apply 3M - autobody repa1r tape.
--~A
----
"'
~s,de
:=~. -..•. _ / - _ - / _ - ·_
surface
---------\ '0/--~~:_
A001007003
Using filler
- Structural adhes1ve tube k1t
Part number 8101
3M brand
Or:
- Flexible parts repair matenal
Part numoer: 05900
3M brand
o
NOTE: E1ther fillers can be used for repairs.
Properly mix the two components
Apply mixed filler w1th a spatula
A001007004
Section 07 CHASSIS
Sub-section 01 (HOOD)
Let filler set and dry for 20 to 30 minutes. If required,
sand and apply finishing coat and allow to dry
~~
~~
'-h~_s!e~n_s~·~
A001007005
Use one of these two lacquers:
1 Lucile h1gh gloss acryliC lacquer from Dupont for all
bnght surfaces
0
NOTE: Th1s lacquer can also be purchased tn a sat-
in fin1sh _ Luc1te Plast1c Res1n no. 1555 can be add-
ed 1n amounts not to exceed 5% by volume.
2 SICO polyurethane pa1nt no. 585183 with SICO
catalyst 581004 Mix 3 parts of paint for 1 part of
catalyst
Use conventional spray equipment for touch-up.
After pa1nting, apply Acrypol Polish Compound from C-
1-L only on Lucite h1gh gloss acryl1c lacquer
After a 30 to 60 minutes drying period, apply a SUitable
pol1shmg compound to paint on the outer edge of repair-
ed area in order to remove fumes.
Apply lacquer clear no. 300S from Dupont to blend the
general surface only when using Lucile high gloss lacqu-
er. Allow to dry.
Use F1ll'n Glaze pink from 3M on surface to fill swirls and
to produce a high luster finish.
For lightly scratched R.I.M. surface:
Scuff surface area with medium to fine steel wool.
Textured surface finish will be easily duplicated by
applying satin finish acrylic lacquer.
07-01-3