BOMBARDIER ELAN 3042 1985 Shop Manual page 410

Section 05 SUSPENSION
Sub-section 02 (SLIDE SUSPENSION)
I. Runner 121
2. Slider shoe 121
3. Screw M5 x 20 12!
4. Stop nut M5 121
5. Rubber swpper 14)
6. Rivetl4)
7. Push nut 141
8. Swpper 121
9. Screw M5 x 7 2 12!
10. Srop nul M5 121
II. Lower front cross shaft
12. Screw MIO x 25 1101
13. Lock washer 10 mm (14!
14. Loccice 242
15 Front idler shaft
16. Idler wheel shaft 121
17 Snap ring 141
18. Ball beaflng 141
19. Idler wheel 135 mm 12!
20. Flat washer 10 mm 141
21. Screw MIO x 90121
22. Front arm
23. Lower cross shafc 131
24. Bushmg 141
25. Upper cross shaf1 121
26. Franc spring 121
27. Bushing 14!
28. Lock washer 10 mm 141
REMOVAL
43, Adjustment screws
Release track tension by loosening adjustment screws
located on inner side of rear idler wheels.
o
NOTE: It is not required to loosen rear axle screws.
A003005001
screw
05-02-8
29 Screw MIO x 35 141
30. Stopper strap
31 Flar washer 121
32. Screw M8 x 35
33. Slop nur M8
34. Rear arm
35. Sl1der pad 121
35. Sild1ng suppon 121
37. Rear spring 121
38. Shock absorber cross shafl
39. Bushmg
40 Shock absorber
4 I. Clevis p1n
42 Cocrer p1n
43. AdJUStment screw MIO x 75 121
44. Swp nul MIO 12!
45 Square nut MIO 121
45. Rear axle
47 Idler wheel 190 mm 121
48. Screw 121
49. Upper cross shaft
50. Idler wheel/21
51 Ball bearing 12!
52 Spacer 121
53. Lock washer 121
54 Screw M8 x 25 121
55 Snap rmg 121
55 Flat washer 10.5 mm
50,54, Upper idler wheel & screw
Remove both screws then upper idler wheels set.
25,29, Upper cross shaft & screws
Remove the four (4) screws securing front and rear arm
to frame.
Remove suspension system.
0
NOTE: To prevent cross shaft from turning within
the suspension arm, wedge the blade of a small
screwdriver between the shaft and suspension arm.
DISASSEMBLY & ASSEMBLY
1 ,2,3,4,8,9, 10, Runners, slider shoes,
stoppers, screws
&
stop nuts
To replace a worn slider shoe, remove the stopper fasten-
ers, the front screw and stop nut then slide the shoe rear-
wards out of the runner.
5,6, 7, Rubber stoppers, rivets & push nuts
Pry off push nut with a screwdriver to remove. To In-
stall, press push nut while retaining r1vet.