BOMBARDIER ELAN 3042 1985 Shop Manual page 178

Section 02 ENGINE
Sub-section 08 (532 ENGINE TYPE)
A01500201S
'W'
CAUTION: Failure to postition the seals as speci-
T
tied may cause the seal spring to be corroded by
coolant. Severe damage will occur if this notice is dis-
regarded.
13, 14, 15, Bearing 6201, seals & distance ring
0
NOTE: After seals installation, check if the water
pump end bearing is correctly positioned (use push-
er PIN 420 876 500l
A013002028
1 , Rotary valve shaft
To install rotary valve shaft proceed as follows with the
suitable tools:
- pusher PIN 420 876 600
-water pump seal sleeve PIN 420 876 490.
02-08· 18
A01S002018
Seal sleeve
P:l\i 420 876 490
+
•
22,23, Pump housing bolts & Loctite 242
Apply Loctite 242 on bolts thread .
30, Rotary valve cover bolts
Torque the rotary valve cover bolts to 20 N•m (151bf•ft).
25, Rotary valve
Installation on genuine crankcase with mark (ridge).
REQUIRED TOOL
A000001001
T.DC. gauge
P/N 414 1047
00
To correctly install the rotary valve, proc eed as follows:
- Turning crankshaft counterclockwise. (drive pulley
side) bring magneto side to top dead center using a
T.D .C. gauge.
0
NOTE: Do not use crankshaft locking tool to find
out mag. Side top dead center . It will not give the
right position.
- Position the rotary valve on gear in such a way that
its closing edge will be as close as possible to the bot-
tom of the magneto side inlet port, and its opening
edge in line with the mark (ridgel on the upper left
side of the rotary valve cover.
- - -