BOMBARDIER ELAN 3042 1985 Shop Manual page 298

Section 03 TRANSMISSION
Sub-section 05 (PULLEY DISTANCE & ALIGNMENT)
Pulley alignment methods
Drive pulley alignment:
If drive pulley is too far in, remove drive pulley and add
shim(sl on crankshaft . Shim P/N 504 0504 00, 0.81 mm
(032") thickness.
,.,. CAUTION: Never use more than 5 shims on crank-
T
shaft .
..A..
WARNING: Always torque drive pulley bolt within
T
specifications. (See section 03~03).
Driven pulley alignment:
If dnven pulley is too far in, add shim(sl between frame
and chaincase. Shim PIN 504 0504 00, 0.81 mm (032"1
thickness.
Citation LS/E, Tundra, Tundra LT
A00400:l003
'1lllr
CAUTION: The rear suspension must be mounted
T
on the vehicle and track tension and alignment
must be done to provide the right frame width.
0
NOTE: Before checking pulley alignment, the dis-
tance between the two (21 front engine
support
must equal 302 mm
±
1 (11890" ± .039).
03-05-2
Pulley distance specification
36 .6
mm :
1
6
(1
7116"
~
11
661
1 (1 1 890"
±
.039 1
Pulley distance adjustment method
Slack the four (41 chaincase retaining bolts and remove -
cotter pin, clevis pin from the bracket. · .
Move chaincase to obtain specific adjustment and adJUSt
driven pulley support accordingly.
A00400300S.
Clevis
pin