BOMBARDIER ELAN 3042 1985 Shop Manual page 284

Section 03 TRANSMISSION
Sub-section 04 (DRIVEN PULLEY)
REMOVAL
11, 12, 13, 14, 15, Shim, extension, washer ,
lock washer & screw
Remove the cap screw, pull the driven pulley from the
co untershaft .
DISASSEMBLY
1, Snap ring
Remove snap ring to disassemble the outer cam and the
two pulley halves .
4, Sliding half bushing
To d 1 sassemb le a worn bushing, use a press and a suit-
able pusher
AD07003005
INSPECTION
4, Sliding half bushing
Check bushing wear, replace 1f wear is excessive
5, Slider shoe
Check f or excess1ve wear.
3, Spring
Spring torsional pre-load
Check pre-load usi ng a fish scale pOSitioned at 90 ° with
the pulley ax le
The spring pre-load should be: 5 9 kg 113 lbsl
03-04-10
5 .9
k ~
llJ lbsl
A007003006
To correct, refer to ADJUSTMENT.
ASSEMBLY
4, Sliding half bushing
Assemble a new bushing using a press and a su1table
pusher. ·
A00700J007
5, Cam slider shoe
When replacing slider shoes, always install a new set of
three shoes to maintain balanced pressures on the cam.
INSTALLATION
Re1nstall the pulley on the countershaft by revers ing the
removal procedure .
19, Countershaft
.,_.CAUTION: Always apply anti-seize compound
T
on the countershaft before final pulley installa-
tion (loctite anti-seize lubricant P/N 413 7010 00).
- -