BOMBARDIER ELAN 3042 1985 Shop Manual page 241

6,
7,8,
Rope sheave, starter rope
&
key
To install a new rope : insert rope into sheave orifice and
loc k it with the key as illustrated
A0010 0 20.11
To adJust rope tension :
Push
to lock
Wind rope on sheave and place rope sheave 1nto starter
housing making sure that the sheave hub notch engages
m the spring hook .
Rotate the sheave counterclockwise until rope end is
accessible through starter housing orif ice
Pull the rope out of the starter houstng and temporarily
make a knot to hold it.
A 00 10 0 10l:l
1 \Urn preload will g1ve
7 !urns ol 1e11sion when
h 1ily
extended
9, 1 0, 11, Pawl, pawl lock & circlip
Position pawl, pawl lock and circlip.
Section 02 ENGINE
Sub-section 13 (REWIND STARTER)
1
2,
Lock spring
Install lock spnng and lubricate wt th MO L YKO TE G-N
paste PIN
413 7037 00 .
Install lock rmg .
.._.CAUTION: This lubricant must not be used on re-
T
wind springs as it does not stay on when dry.
INSTALLATION
On fan coole d n1ode:s with oil 1 nwc t1 0n pump , rems ta/1
oil pump on rewind starter asse mbly
Remstall rewmd starter assembly on eng1ne.
0
NOTE:
If applicable, connect hood retain1ng cable
to rewind sta rter retainer bolt
Pr1or to mstalilng starter grip on new rope, it 1s first ne-
cessary to fuse the rope end with a lit match. Pass rope
through rubber buffer and starter gr1 p, and t1e a kn ot in
the rope end. Fuse the knot wi'h a lit match then turn
the knot end down and pull the starter gri p ove r the knot.
AOO 1 00:1'044
02-13·3