BOMBARDIER ELAN 3042 1985 Shop Manual page 136

Section 02 ENGINE
Sub-section 06 (467 ENGINE TYPE)
CLEANING
Discard all seals and 0-rings.
Clean all metal components in a non-ferrous metal cleaner.
DISASSEMBLY & ASSEMBLY
6,24, Pump impeller & circlip
To remove rotary valve shaft assembly from crankcase,
first remove coolant pump impeller and circlip. Using the
suitable pusher (PIN 420 876 6101 and a f1ber hammer.
push shaft assembly.
Tool no 420 876 610
A015002012
'1lr
CAUTION: To prevent damage to the end of the
T
rotary valve shaft, use pusher (tool PIN 420 876
6101.
17,18, Spring retaining cup & circlip
If it is necessary to disassemble components of rotary
valve shaft assembly, compress spring retaining cup in
order to remove circlip.
A01JCX)2012
02-06-16
11,12. Distance sleeve & Loctite 271
To remove the distance sleeve use a bearing puller I Ex:
Snap-on no. CJ 9501 and pusher I PIN 420 876 6101 as
illustrated. Heat the distance sleeve to break . the Loctite
bond 93°C 1200°FI and proceed as illustrated
Bearing puller
ISnap ·on CJ 9501
'1lr
CAUTION: Ensure that the rotary valve shaft is
T
perfectly perpendicular with the press tip or dam-
age will occur.
Clean rotary valve shaft and inside of distance sleeve. At
assembly apply Loctite 271 inside of distance sleeve.
7 ,8, Rotary valve shaft
&
seal
At assembly apply lithium grease on seal lips. Position
the seal with shielded portion towards rotary valve.
Seal Ball bear~ng
A0 1l00201<1
7,9, Rotary valve shaft & bearing 6203
At assembly, apply crankcase sealant Loctite 515 on
bearing and rotary valve shaft mating surfaces.
TCAUTION: Don't put any Loctite on bearing balls.
. e