BOMBARDIER ELAN 3042 1985 Shop Manual page 216

Section 02 ENGINE
Sub-section 10 (ENGINE DIMENSIONS MEASUREMENT)
- Install the bearrng retainer into rts groove on MAG srde.
4001002035
- Measure the gap between the bearing retainer and the
bea ring simulator close to the crankcase half.
PTO
A001002035
PT O shtm
instal led
Bea nng
simulator
Bearing
retam er
Measure
the gap
-This gap is the actual crankshaft end-play. Add
shim(s) to reach the specified end-play by repeating
the procecures .
- Install MAG side bearing . Refer to 253 engine type
section 02-02, Bottom end portion .
377,447,462,467,503,532,537 engine
types
These engrne types do not have end-play adjustment.
02-10-6
CRANKCASE/ROTARY VALVE GAP
ENGINE TYPE MINIMUM MAXIMUM
All 1985 0 27
mm 0.48
mm
liquid cooled 10.011") (0 0 19 " )
To measure thrs gap use a feeler gage inserted between
rotary valve and upper crankcase with the rotary valve
cover in place without it's 0-ring . Check the most su r-
face as possible . Follow the same procedure with the
lower crankcase .
- - -