BOMBARDIER ELAN 3042 1985 Shop Manual page 51

- - - - - - -- - -- - · -
· - - · - · -- - -
- tighten puller bolt and at same time, tap on bolt head
using a hammer to release magneto from its taper.
REPAIR
18, Generating coil
To replace generating coil:
-Heat the armature plate to 93°C 1200°F) around the
screw holes to break the Loctite bond .
.001001003
T
CAUTION: Protect harness from flame.
-Remove screws (use Phillips no. 2 or suitable flat screw
driver).
- Cut the four wires as close as possible to the coil body.
- To pass new coil wires in harness, tape the old wires
to the end of new wires and pull them through the
harness protector tube.
- Insert the new wires into the old connector housing
and install connectors.
Section 02 ENGINE
Sub-section 02 (253 ENGINE TYPE)
.._CAUTION: Replace the old wires in the connector
'Y
with the same color coded new wires.
- Install a new receptacle connector to the black/yel-
low striped wire.
- To install the ground connector of the armature plate,
tape the new black lead to the old one and pull it under
the lighting coil with the old wire.
- Solder an eye connector to the lead and fasten it under
the wire retaining clip .
Wire retaming clop
Eye connector
AOOt002005
- To install the new coil on the armature plate, remove
the shipping nuts from the coil and apply Loctite 242
(blue, medium strength) to screws before assembly .
.._CAUTION: Before reinstalling the magneto, re-
T
move the loose epoxy from harness.
12,13,21,22, Protector tubes, splice con-
nectors, lighting coil & screws
To replace lighting coil:
-Heat the armature plate to 93°C (200°Fl around the
screw holes to break the Loctite bond.
Heat
A001002003
Protect harness
from flame
TCAUTION: Protect harness from flame.
-Remove screws (use Phillips no. 3 screwdriver).
- Remove the wire retaining clip from armature plate.
- Pull out protector tubes and unsolder the splice con-
nectors.
02-02-11
1