BOMBARDIER ELAN 3042 1985 Shop Manual page 268

Section 03 TRANSMISSION
Sub-section 03 (DRIVE PULLEY)
6, 15, 16, Hub plug
The hub plug 1s pushed by the clutch spring pressure .
At disassembly, hold hub plug firmly against outer half
until the three {3) bolts are completely removed. This will
prevent damage of the outer half threads .
5,8, "Duralon" bushing
To disassemble "Duralon" bushing from hub plug, use
a suitable pusher and hammer or press
"W'
CAUTION: Do not disassemble counterweights
T
unless replacement is necessary.
CLEANING
1 ,2, Inner & outer half
Inside of outer half should be cleaned with a clean cloth.
The square shaft can be cleaned with fine stele wool and
a clean Cloth
1 , Inner half & crankshaft
Using cleaner such as acetone, clean crankshaft taper-
ed end and the taper inside the fixed half of the drive
pulley .
+
WARNING: This procedure must be performed in
a well ventilated area.
"W'
CAUTION: Avoid contact between crankshaft
T
seal and acetone because damage may occur.
INSPECTION
Drive pulley should be inspected annually .
25, Roller
Check for roundness of external diameter .
21, Shouldered pin bushing
Check for excess ive wear .
Install new one with Loct ite 242
8, "Duralon" bushing
Inspect the "Duralon" bushing condition by checking
the free-play of the sliding half pulley. This is ach1eved
by restraining the 1nner half and checking if the sliding
half moves in the direction of the arrows more than 3
mm
11;8") .
03-03-14
A007003004
Mark reference
point
on both halves
Maximum lree-play
3
mm
(118"1
"W'
CAUTION: Ensure rollers are in good condition.
T
Replace as required.
ASSEMBLY
3,4, Guard
Torque to 6 N•m !53 lbf•1nl
5,6,8, "Duralon" bushing
To install or remove "Duralon" bushing from hub plus ,
use su1table pusher and hammer or . press . Install bus-
hing as per illustration .
A015003002
GJind
taper
" Duralon " bush ing