BOMBARDIER ELAN 3042 1985 Shop Manual page 195

CLEANING
Clean all metal components 1n a non-ferrous metal clean-
er.
'W'
CAUTION: Clean armature and magneto using
T
only a clean cloth.
DISASSEMBLY
To ga1n access to magneto assembly, remove:
-muffler
-rewind starter
- starting pulley
0
NOTE: Before d1sassembling magneto plate, index-
ing marks should be located to facil1tate reassem-
bly.
20, Flywheel retaining nut
To remove magneto flywheel retaining nut:
-- lock crankshaft w1th crankshaft lockmg tool lserv1ce
tool) as Illustrated (magneto s1de p1ston must be at
top dead center)
- remove magneto reta1n1ng nut
AO I 5002001:!
0
NOTE: It should be noted that to correctly remove a
Loctite locked fastener 1t IS f1rst necessary to tap
on
thl~
fastenr:r to break thr" Loct1te bond
T
h1s will ele-
minate the possib1l11y of thread breakage
Section 02 ENGINE
Sub-section 09 (537 ENGINE TYPE)
11 , Flywheel
To remove magneto housmg (flywheel)
-- lock crankshaft with crankshaft lock1ng tool (service
tool) as Illustrated,
- adjust magneto housing puller and puller ring as Illus-
trated,
401 !>002()09
Magrh3to. 'loustng
pu:!er and
r1ng
iP N 420 876 0651
- t1ghten puller bolt and at same time, tap on bolt head
using a hammer to release magneto from its taper.
REPAIR
2, Generating coil
To replace generating coil:
heat the armature plate around the screw holes to
break the Loct1te bond 93
°
C 1200
a
F).
Protect
l1drncss
from flamn
AU0100200J
Heat
TCAUTION:
Protect harness from flame.
02-09-11