BOMBARDIER ELAN 3042 1985 Shop Manual page 137

~ -~-----·-~- -~-~ - ~~~~ ~- ---------------
Install ball bearing as illustrated.
A013002015
Bearmg puller
tSnap~on CJ 9501
19,20,21, Bearing 6201, seal & distance ring
To remove bearing 6201 (the smallest one), seals and
distance ring use pusher IP/N 420 876 510)
A015002013
To install ball beanng 6201 use ball bearing pusher (PIN
420 876 500)
A013002029
0
NOTE: Ball bearing shielded side must be facing ro-
tary valve.
Section 02 ENGINE
Sub-section 06 {467 ENGINE TYPE)
20,21, Seals & distance ring
To install seals on water pump side proceed as follows :
A01500.2014
Apply some lith ium grease or equivalent on seal lips. Post-
lion all seals with shielded portion toward s water pump
using pusher !PIN 420 876 510) Align distance ring open-
ing with crankcase draining hole (see note and illustra-
tion) Push seals and distance ring assembly against
bearing.
0
NOTE: 35% of the distance between first and se-
cond seals must be filled with lithium grease or
equivalent.
0
NOTE: The dra ining hole is used to detect seal
malfunctions If you notice oil , or coolant at the exit
of the drain tng hole, thi s mean that oil sea l or coolant
seal leaks~
~CAUTION:
Failure to position the seals as speci-
T
tied may provocate the seal spring to be corroded
by coolant. Severe damages will occur if these notices
are disregarded.
02-06-17