BOMBARDIER ELAN 3042 1985 Shop Manual page 71

18, Magneto flywheel
To remove magneto hous1ng !flywheel)
- lock crankshaft with crankshaft locking tool )service
tool) and adjust' magneto housing puller and puller ring
!service tool) as illustrated .
Crankshaf t
locking too:
PIN 420 876 640
.0. 00900200 7
Magneto hou stng
puller and rtng
r----------
1
\~
I
I
I
P•N 420 876 065
I
PIN 420 876 655
I L ___________ _.
-tighten puller bolt and at same time , tap on bolt head
using a hammer to release magneto from tis taper
0
NOTE: For the above procedure. the locktng type
puller can be used without crankshaft locking tool.
PI N 420 876 065 PIN 420 876 080
A009002083
REPAIR
26, Generating coil
To replace generating coil:
-Heat the armature plate to
93°
C
1200°
Fl around
the screw holes to break the Loctite bond.
Section 02 ENGINE
Sub-section 03 (377 ENGINE TYPE)
Protect harness
from flame
A00100200J
Heat
TCAUTION: Protect harness from flame.
- Remove screws (use Phillips no . 2 or suitable flat
screw driver).
-- Cut the four wires as close as possible to the coil body .
-To pass new coil wires in harness, tape the old wires
to the end of new w1res and pull them through the
harness protector tube.
·- Insert the new wires into the old connector housing
and tnstal l connectors .
Insert
new wires
A001002004
02-03-13