BOMBARDIER ELAN 3042 1985 Shop Manual page 429

Section 05 SUSPENSION
Sub-section 05 (PAS SUSPENSION)
- Remove the snap ring then th e bearing .
At assembly reverse the procedure.
0
NOTE: To remove the front idler wheel s cross shaft.
the runner must be removed (the cross shaft rs
shouldered) .
44,47,62,63, 78,83,84, Screw, nut, rear
shackle, rear arm, rear shock, screw
&
spacer
To remove rear shock:
- Withdraw spacer from shock pivot
- Unscrew bolt and nut
- Inspect shock nylon bushings condition .
At assembly reverse the procedure.
If rear arm and/or rear shackle have been removed, make
sure to reposit ion them properly :
- Position the grease fittrngs pointed forward on the rear
shackle.
- See illustration to properly posit io n the rear arm
, . CAUTION : Make sure installing washer 99 each
T
end of the rear shackle lower axle.
Grease fot ungs
pointed for w ard
6,86,87,88, Screw, inner spacer, rear axle
&
outer spacer
To remove:
- Unscrew retaining screw.
-- Pull idler wheel.
- Remove the runner to take the rear axle off.
At assembly, reverse the procedure. However pay atten-
tion to the following :
-- Posit1on 1nner and outer spacer as shown .
05-05-4
A.01!500SOIB
Thic ker section :
either on lop or
Jt th e bottom
. . . CAUTION: It is important to properly position the
T
inner and outer spacers. Disregarding this notice
might cause rear axle failure.
-Position notch on rear axle forward .
- Position hole in outer spacer forward and inward onto
the rear axle
6,32,67, 77,83,97, Screws & Loctite 271
Clean all screw threads. Prior to assembly, apply a light
coat of Loctite 271 or equivalent on threads.
INSTALLATION
- Lift the rear of vehicle off the ground about 850 mm
!33
112")
A01SOOSOOt