BOMBARDIER ELAN 3042 1985 Shop Manual page 68

Section 02 ENGINE
Sub-section 03 (377 ENGINE TYPE)
5, 13, Oil seal P.T.O. side & oil seal mag. side
At seal installation. apply a light coat of lithium grease
on 1ns1de d1ameter lip of seals.
For beanng lubricatiOn purpose, a gap of
1.0
mm
(.040")
must be mainta1ned between seals and bearings. When
Installing plain seals (Without locattng ring or without
spacing legs). ensure to maintain the specified gap as
illustrated.
A009002004
2, 18, 1 9, Upper crankcase, lower crankcase
&
Loctite
Crankcase halves are factory matched and therefore, are
not interchangeable as single halves.
Prior to joining of crankcase halves, spray some new In-
jection oil on all the moving parts of the crankshaft.
0 NOTE: Prior to apply1ng Loctite 515 it IS possible
to use primer N (P/N 413 7053 OOl or primer NF
(P/N 413 7020 001. Th1s mcreases cure speed and gap
filling capability. Refer to supplier Instructions.
Position the crankcase halves together and tighten nuts
(or bolts) by hand then install armature plate (tighten)
on magneto side to correctly al1gn the crankcase halves.
Torque bolts to proper torque following illustrated se-
quence
02-03-10
Follow sequence shown
All the other bolts
are torque to 21 N•m 115 lbf•fll
9 N•m 180 lbf•ml
9 N•m 180 lbf•rn)
A009002005
21, 26, Screws M8 x 45, M8 x 70
The b1gger screws have to be torqued to 21 N•m I 15
lbf•ft)
28, Screws M6 x 40
The smaller screws have to be torqued to 9 N•m (7
lbf•ft)
To 1nstall magneto, refer to "Magneto" in this section.