BOMBARDIER ELAN 3042 1985 Shop Manual page 295

25,27, Roll pin & outer cam
Rem ove roll pm and slide outer cam out of pulley shall.
23, Sliding half bushing
To disassemble a worn bush1ng, usP. a press and a
sui table pusher .
A007003005
INSPECTION
23, Sliding half bushing
Check slidmg ha lf bushing wear, replace bushing if
w ear is excessive .
26, Slider shoe
Check for excessive wear .
24, Spring
Spring torsional pre-load
Check pre- load using a f1sh pOSitioned at 90 ° with the
pulley axle.
The spnng pre-load shou ld be 3 6 kg (8 lbsl.
3 6
l<g
18 lbsl
A00700J006
To correct, refer to ADJUSTMENT .
Section 03 TRANSMISSION
Sub-section 04 (DRIVEN PULLEY)
ASSEMBLY
23, Sliding half bushing
Assemble a new bushing using a p'ess and a su1table
pusher .
A00700J007
Driven pulley & chaincase
Assemble by rev ersing the disassembly procedure.
19, Fixed half shaft
'W'
CAUTION: Always apply anti-seize compound
T
on the pulley shaft before final pulley installation
(loctite anti-seize lubricant P/N 413 7010 001 .
26, Cam slider shoe
When repla cmg slider shoes . always install a new set
of three shoes to ma1nta1n balanced pressures on the
cam .
INSTALLATION
Drive pulley & chaincase
Reinstall by reversing the removal pro cedu re
ADJUSTMENT
24, Spring
Spring torsional pre-load
To adjust spring pre-load displace spring end accordingly .
A00700J01 1
03-04-19