BOMBARDIER ELAN 3042 1985 Shop Manual page 122

Section 02 ENGINE
Sub-section 06 (467 ENGINE TYPE)
I. "467"
engine
2.
Srud MIO x T8i T8
3.
Clamp
4. Hexagonal etas1ic srop nur MIO
5.
Support
6
Rubber washer
7. Washer
8. Hexagonal elas!lc srop nul MIO
9.
Front support 121
10 Righl
rear support
II. Lefl rear suppon
12. Lock washer 8 mm
18!
13.
Allen screw M8 x 25 181
14. Bounding rubber mounr 141
15. Lock washer 8 mm 181
16. Allen screw M8 x 20 1 81
17. Fronr supporr 121
18. Rear suppon 121
19. Flanged hexagonal elas/Jc SlOP nul M8 18!
20 Lock washer 141
2 1 . Spring lock washer 10 mm 141
22. Hexagonal head cap screw M10 x 20 141
REMOVAL FROM VEHICLE
Disconnect or remove the following from veh1cles:
- Air silencer.
- Pulley guard and drive belt
- Throttle cable from carburetors and oil injection pump.
- Fuel line:>, pulsation line and primer tubes.
- Ignition coil and rotary valve reservoir
- Electrical connectors and wires.
- Single tuned pipe.
- Rewind starter.
- Engine torque rod nut litem #8) .
- Drain the cooling system and disconnect hoses from the
engine !see "Cooling system" in this section}.
- 4 screws retaining engine supports on frame.
ENGINE SUPPORTS
&
MUFFLER
DISASSEMBLY & ASSEMBLY
22,26, Engine support screw & manifold
screw
Torque the engine supports screws to 48 N•m (35 lbf•ftl.
Torque the man1fold screws to 21 N•m !15 lbf•ftl.
02·06·2
23 G< Hkel 121
24 EKhausl manifold
25. Lock washer 8 mm
26 Cyilndncal screw M8 x 30
27.
Spring
28
S•ngle exhaust p1pe
29.
Female ball JOint
30 Hexagonal head cap screw M6 x 30
31. U·bracket
32. Pipe bracket
33. Flanged elaSflc hexagonal stop nut M6 131
34.
Rubber spacer
35.
Asbestos washer
36 Exhaust pipe supporr
37.
Spring
38.
Spring 161
39. rail pipe
40 Muffler
41. Exhausr grommet
42.
Rubber buffer
43.
Starter gnp
INSTALLATION ON VEHICLE
To mstall engine on vehicle, reverse removal procedure.
However, pay attention to the following :
- Check tightness of engine rubber mounts screws and
supports nuts. Torque to 25 N•m 118 lbf•ftl.
- After throttle cable installation, check carburetor maxi ·
mum throttle opening and oil injection pump adjust-
ment
- Check pulley alignment and drive belt tension.
~CAUTION:
A red dot is printed on one carburetor
T
and on oil pump mounting flange. Match the
marked carburetor to the side marked on the oil pump
mounting flange (magneto side) . This is required be-
cause of the different jettings.