BOMBARDIER ELAN 3042 1985 Shop Manual page 172

Section 02 ENGINE
Sub-section 08 (532 ENGINE TYPE)
10, Protector tube
Pos1t1on protector tubes over connections .
6, 7, Loctite 242 & lighting coil screws
Prior to assembly , apply Loctite 242 (blue, medium
st rength I
··· Fasten retaining clip onto protector tubes .
The ground terminal fr om generating coil must be fasten-
ed under this clip.
AOOW02 00~
.._.CAUTION: Before reinstalling magneto remove
T
the loose epoxy from harness.
ASSEMBLY
1,7,12,13,14, Armature plate, Loctite 242,
washers, lock washers & nut
Pos1tion the armature plate on the crankcas e, al1gning
the marks on both parts .
Put a drop of Locti te 242 on screw thread s and t1 ghten .
Clean crankshaft exten sion ltaperl.
Apply Lo ctite 24 2 on taper .
7,11, 19,20, Loctite 242, flywheel, lock
washer
& nut
Positio n woodru ff key, magneto flyw heel. lock w ash er
on crank shaft .
Clean nut threa ds an d apply Loctite 242 I blue . med1urn
strength ) before tightening nut to 95 N•m 170 lbf•ftl
At reasse m bly coat all electr1 c connect1on s w1th Silicone
dielectric g rease
(P!N 41 3 7017 001 to prevent
corros1on
or m o1stu re pene tratiOn
.._.CAUTION: Do not use silicone "sealant", this
T
product will corrode contacts.
0
NOTE: For mg intiOn tim1ng procedure refer to '' Igni-
tion timing" section 0 4-02 .
02-08· 12