Common Configuration Tasks; Enabling Ldp - Alcatel-Lucent 7450 Manual

Common Configuration Tasks

Common Configuration Tasks
This section provides information to configure:
•
•
•
•
•
•
•
•

Enabling LDP

LDP must be enabled in order for the protocol to be active. MPLS does not need to be enabled on
the router except if the network interface uses the Packet over Sonet (POS) encapsulation (Sonet
path encapsulation type set to ppp-auto). In this case, MPLS must be enabled and the interface
name added into MPLS to allow for the MPLSCP to come up on the PPP link between the two
peers and for MPLS to be used on the interface. MPLS is enabled in the
context.
Use the following syntax to enable LDP on a router:
CLI Syntax: ldp
Example:
The following displays the enabled LDP configuration.
A:ALA-1>config>router# info
----------------------------------------------
...
#------------------------------------------
echo "LDP Configuration"
#------------------------------------------
----------------------------------------------
Page 622
Enabling LDP on page 622
Configuring FEC Originate Parameters on page 624
Configuring Graceful-Restart Helper Parameters on page 625
Applying Export and Import Policies on page 626
Targeted Session Parameters on page 628
Interface Parameters on page 629
Session Parameters on page 630
Interface Parameters on page 629
config>router# ldp
ldp
session-parameters
exit
interface-parameters
exit
targeted-session
exit
exit
config>router>mpls
7450 ESS MPLS Guide