Alcatel-Lucent 7450 Manual page 244

MPLS Commands
in-label
Syntax in-label in-label out-label out-label out-link if-name [next-hop next-hop]
no in-label
Context config>router>mpls>mpls-tp>transit-path>forward-path
config>router>mpls>mpls-tp>transit-path>reverse-path
Description This command configures the label mapping associated with a forward path or reverse path of an
MPLS-TP transit path to be configured.
The incoming label, outgoing label and outgoing interface must be configured, using the in-label,
out-label and out-link parameters. If the out-link refers to a numbered IP interface, the user may
optionally configure the next-hop parameter and the system will determine the interface to use to
reach the configured next-hop, but will check that the user-entered value for the out-link corresponds
to the link returned by the system. If they do not correspond, then the path will not come up.
Default no in-label
Parameters in-label — Specifies the in label.
out-label — Specifies the out label.
if-name — Specifies the name of the outgoing interface use for the path.
next-hop — Specifies the next-hop.
shutdown
Syntax [no] shutdown
Context config>router>mpls>mpls-tp>transit-path
Description This command administratively enables or disables an MPLS-TP transit path.
Default
no shutdown
Page 244
Values 32 — 16415
Values 32 — 16415
Values
a.b.c.d
7450 ESS MPLS Guide