Alcatel-Lucent 7450 Manual page 217

lsp-template
Syntax lsp-template template-name [p2mp | one-hop-p2p | mesh-p2p]
no lsp-template template-name
Context config>router>mpls
Description
This command creates a template construct that can be referenced by client application where
dynamic LSP creation is required. The LSP template type p2mp, one-hop-p2p, or mesh-p2p is
mandatory.
The no form of command deletes LSP template. LSP template cannot be deleted if a client
application is using it.
Parameters lsp-template-name — Specifies the name of the LSP template. Any LSP template name and LSP
p2mp | one-hop-p2p | mesh-p2p — Identifies the t ype of the LSP this template will signal.
lsp-init-retry-timeout
Syntax lsp-init-retry-timeout seconds
no lsp-init-retry-timeout
Context config>router>mpls
Description This command configures the initial LSP path retry-timer.
The new LSP path initial retry-timer is used instead of the retry-timer to abort the retry cycle when no
RESV is received. The retry-timer will govern exclusively the time between two retry cycles and to
handle retrying of an LSP path in a failure case with PATH errors or RESVTear.
The intent is that the user can now control how many refreshes of the pending PATH state can be
performed before starting a new retry-cycle with a new LSP-id. This is all done without affecting the
ability to react faster to failures of the LSP path, which will continue to be governed by the retry-
timer.
The no form of this command returns the timer to the default value.
Parameters seconds — Specifies the value, in seconds, used as the fast retry timer for a secondary path.
7450 ESS MPLS Guide
name must not be the same.
Values 10—600
Default
30
MPLS and RSVP
Page 217