Alcatel-Lucent 7450 Manual page 486

GMPLS Commands
The no form of this command removes the far-end address
Default no far-end
Parameters ip-address — Specifies an IPv4 or IPv6 address of the far-end UNI-C router.
member
Syntax [no] member member-id
Context config>gmpls-tun-grp
Description This command configures a member of a GMPLS tunnel group. A member of a GMPLS tunnel
group is a GMPLS LSP. All members of a tunnel group must have the same bandwidth. Up to 16
members may be configured for each GMPLS tunnel group.
The no form of this command removes the member.
Default
no member
Parameters member-id — Specifies the identifier of the GMPLS tunnel group member.
glsp
Syntax [no] glsp session-name name
Context config>gmpls-tun-grp>member
Description This command binds a GMPLS LSP as a member of the GMPLS tunnel group. The session name is
used to identify the GMPLS LSP. This is the LSP name of the GMPLS LSP.
The no form of this command removes the member.
Default
none
Parameters session-name name — Specifies the session name of the GMPLS LSP.
Page 486
Values ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x (eight 16-bit pieces)
Values 1 — 16
Values
80 characters maximum text string
x:x:x:x:x:x:d.d.d.d
x — [0..FFFF]H
d — [0..255]D
7450 ESS MPLS Guide