Alcatel-Lucent 7450 Manual page 402

[excl-node-id..(up to 8 max)]] [skip-interface interface-name] [ds-class-type class-type]
[cspf-reqtype req-type] [least-fill-min-thd thd] [setup-priority val] [hold-priority val]
Context tools>perform>router>mpls
Description
This command computes a CSPF path with specified user constraints.
Default
none
Parameters to ip-addr — Specify the destination IP address.
from ip-addr — Specify the originating IP address.
bandwidth bandwidth — Specifies the amount of bandwidth in mega-bits per second (Mbps) to be
include-bitmap bitmap — Specifies to include a bit-map that specifies a list of admin groups that
exclude-bitmap bitmap — Specifies to exclude a bit-map that specifies a list of admin groups that
hop-limit limit — Specifies the total number of hops a detour LSP can take before merging back onto
exclude-address ip-addr — Specifies IP addresses, up to 8, that should be included during setup.
use-te-metric — Specifies the use of the traffic engineering metric used on the interface.
strict-srlg — Specifies whether to associate the LSP with a bypass or signal a detour if a bypass or
srlg-group grp-id — Specifies up to 8 Shared Risk Loss Groups (SRLGs). An SRLG group
exclude-node excl-node-id — specifies a list of address that should be excluded when this LSP is
skip-interface interface-name — Specifies an interface name that should be skipped during setup.
ds-class-type class-type — Specifies the class type (CT) associated with this LSP.
cspf-reqtype req-type — Specifies the req. type.
least-fill-min-thd thd — Specifies whether the use of the least-fill path selection method for the
setup-priority val — Specifies the setup priority to use when insufficient bandwidth is available to
Page 402
reserved.
should be included during setup.
should be included during setup.
the main LSP path.
detour satisfies all other constraints except the SRLG constraints.
represents a set of interfaces which could be subject to the same failures or defects and thus share
the same risk of failing.
Values 0 — 4294967295
setup.
Values
0 — 7
Values all, random, least-fill
computation of the path of this LSP is enabled.
Values 1 — 100
setup an LSP.
Values
0 — 7
7450 ESS MPLS Guide