Mpls Configuration Management Tasks; Deleting Mpls; Modifying Mpls Parameters - Alcatel-Lucent 7450 Manual

Ethernet service switch

Hide thumbs Also See for 7450:

Table of Contents

MPLS Configuration Management Tasks

This section discusses the following MPLS configuration management tasks:

NOTE: In order to remove the MPLS instance, MPLS must be disabled (shutdown) and all

SDP bindings to LSPs removed. If MPLS is not shutdown first, when the no mpls command

is executed, a warning message on the console displays indicating that MPLS is still

administratively up.

When MPLS is shut down, the no mpls command deletes the protocol instance and removes

all configuration parameters for the MPLS instance.

To disable MPLS, use the shutdown command.

To remove MPLS on a router, enter the following command:

CLI Syntax: config>router# no mpls

NOTE: You must shut down MPLS entities in order to modify parameters. Re-enable (no

shutdown) the entity for the change to take effect.

Modifying MPLS Parameters on page 186

Modifying MPLS Path Parameters on page 188

Modifying MPLS Static LSP Parameters on page 189

Deleting an MPLS Interface on page 190

7450 ESS MPLS Guide