Configuring A Static Lsp - Alcatel-Lucent 7450 Manual

Configuring an MPLS LSP

Configuring a Static LSP

An LSP can be explicitly (statically) configured. Static LSPs are configured on every node
along the path. The label's forwarding information includes the address of the next hop router.
Use the following CLI syntax to configure a static LSP:
CLI Syntax: config>router>mpls
The following displays a static LSP configuration example:
A:ALA-1>config>router>mpls# info
----------------------------------------------
...
...
----------------------------------------------
A:ALA-1>config>router>mpls#
Page 180
static-lsp lsp-name
to ip-address
push out-label nexthop ip-addr
no shutdown
static-lsp "static-LSP"
to 10.10.10.124
push 60 nexthop 10.10.42.3
no shutdown
exit
7450 ESS MPLS Guide