Alcatel-Lucent 7450 Manual page 742

Show Commands
discovery
Syntax discovery [{peer [ip-address]} | {interface [ip-int-name]}] [state state] [detail] [adjacency-
type type]
discovery [state state] [detail|summary] [adjacency-type type] [session ip-addr[label-
space]]
discovery [state state] [detail|summary] [adjacency-type type] [family]
discovery interface [ip-int-name] [state state] [detail|summary] [session ip-addr[label-
space]]
discovery peer [ip-address] [state state] [detail|summary] [session ip-addr[label-space]]
Context show>router>ldp
Description
This command displays the status of the interfaces participating in LDP discovery.
Parameters peer ip-address — Specifies to display the IP address of the peer.
interface ip-int-name — The name of an existing interface. If the string contains special characters
state state — Specifies to display the current operational state of the adjacency.
detail — Specifies to display detailed information.
family — Displays either IPv4 or IPv6 LDP session information.
adjacency-type type — Specifies to display the adjacency type.
Output LDP Discovery Output — The following table describes LDP discovery output fields.
Page 742
(#, $, spaces, etc.), the entire string must be enclosed within double quotes.
Values established, trying, down
Values link, targeted
Label
Interface Name
Local Addr
Peer Addr
Adj Type
State
No. of Hello Adja-
cencies
Up Time
Hold-Time Remain-
ing
The name of the interface.
The IP address of the originating (local) router.
The IP address of the peer.
The adjacency type between the LDP peer and LDP session is targeted.
Established — The adjacency is established.
Trying — The adjacency is not yet established.
The total number of hello adjacencies discovered.
The amount of time the adjacency has been enabled.
The time left before a neighbor is declared to be down.
Description
7450 ESS MPLS Guide