Table of Contents
Advertisement
Common Configuration Tasks
The following sections describe basic system tasks.
•
•
•
•
•
•
Configuring a System Name
Use the
string. Only one system name can be configured. If multiple system names are configured, the last
one configured will overwrite the previous entry.
If special characters are included in the system name string, such as spaces, #, or ?, the entire string
must be enclosed in double quotes. Use the following CLI syntax to configure the system name:
CLI Syntax: config# system
Example
The following example displays the system name output.
A:ALA-A>config>system# info
#------------------------------------------
# System Configuration
#------------------------------------------
Page 62
Configuring a System Name on page 62
Configuring Interfaces on page 63
Configuring a System Interface on page 63
Configuring a Network Interface on page 63
Configuring Proxy ARP on page 67
Creating an IP Address Range on page 70
Configuring an Autonomous System on page 76
Configuring Overload State on a Single SFM on page 77
command to configure a name for the device. The name is used in the prompt
system
name system-name
:
config# system
config>system# name ALA-A
ALA-A>config>system# exit all
ALA-A#
name "ALA-A"
location "Mt.View, CA, NE corner of FERG 1 Building"
coordinates "37.390, -122.05500 degrees lat."
snmp
exit
. . .
exit
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
