Alcatel-Lucent 7450 Manual page 212

MPLS Commands
hold-timer
Syntax hold-timer seconds
no hold-timer
Context config>router>mpls
Description
This command specifies the amount of time that the ingress node holds before programming its data
plane and declaring the LSP up to the service module. This occurs anytime the ingress node brings up
an LSP path or switches traffic from a working path to another working path of the same LSP.
The no form of the command reverts the hold-timer to the default value.
Parameters seconds — Specifies the time, in seconds, for which the ingress node holds before programming its
Default 1 second
ingress-statistics
Syntax ingress-statistics
Context config>router>mpls
Description This command provides the context for the user to enter the LSP names for the purpose of enabling
ingress data path statistics at the terminating node of the LSP, for example, egress LER.
Default
none
least-fill-min-thd
Syntax least-fill-min-thd percent
no least-fill-min-thd
Context config>router>mpls
Description This parameter is used in the least-fill path selection process. When comparing the percentage of least
available link bandwidth across the sorted paths, whenever two percentages differ by less than the
value configured as the least-fill-min-thresh, CSPF will consider them equal and will apply a random
number generator to select the path among these paths
The no form of the command resets this parameter to its default value.
Default 5
Parameters percentage — Specifies the least fill minimum threshold value as a percentage.
Page 212
data plane and declaring the LSP up to the service module.
Values 0 — 10
Values 1 — 100%
7450 ESS MPLS Guide