Configuring Mpls-Tp; Configuration Overview - Alcatel-Lucent 7450 Manual

Ethernet service switch

Hide thumbs Also See for 7450:

Table of Contents

Configuring MPLS-TP

This section describes the steps required to configured MPLS-TP.

The following steps must be performed in order to configure MPLS-TP LSPs or PWs.

At the 7x50 LER and LSR:

1. Create an MPLS-TP context, containing nodal MPLS-TP identifiers. This is configured

2. Ensure that a sufficient range of labels is reserved for static LSPs and PWs. This is

3. Ensure that a range of tunnel identifiers is reserved for MPLS-TP LSPs under

4. A user may optionally configure MPLS-TP interfaces, which are interfaces that no not use

At the 7x50 LER, configure:

1. OAM Templates. These contain generic parameters for MPLS-TP proactive OAM. An

2. BFD templates. These contain generic parameters for BFD used for MPLS-TP LSPs. A

3. Protection templates. These contain generic parameters for MPLS-TP 1-for-1 linear

4. MPLS-TP LSPs are configured under config>router>mpls>lsp mpls-tp

5. Pseudowires using MPLS-TP are configured as spoke-sdps with static PW labels.

At an LSR, a use must configure an LSP transit-path under config>router>mpls>mpls-

tp>transit-path.

The following sections describe these configuration steps in more detail.

7450 ESS MPLS Guide

under config>router>mpls>mpls-tp.

configured under config>router>mpls-labels>static-labels.

config>router>mpls-mpls-tp>tp-tunnel-id-range.

IP addressing or ARP for next hop resolution. These can only be used by MPLS-TP LSPs.

OAM template is configured under config>router>mpls>mpls-tp>oam-template.

BFD template is configured under config>router>bfd>bfd-template.

protection. A protection template is configured under config>router>mpls>mpls-

tp>protection-template.

MPLS and RSVP