Alcatel-Lucent 7450 Manual page 479

shutdown
Syntax [no] shutdown
Context config>router>gmpls>lsp>working-path
Description
This comand administratively enables or disables the GMPLS LSP path.
Default no shutdown
lsp-init-retry-timeout
Syntax lsp-init-retry-timeout seconds
no lsp-init-retry-timeout
Context config>router>gmpls
Description
This command configures the initial GMPLS LSP path retry timer.
The new GMPLS LSP path initial retry timer is used instead of the retry-timer to abort the retry cycle
when no RESV is received. The retry-timer exclusively governs the time between two retry cycles
and to handle retrying of a GMPLS LSP path in a failure case with PATH errors or RESVTear.
The no form of this command returns the timer to the default value.
Default no lsp-init-retry-timeout
Parameters seconds — Specifies the time, in seconds, between retry cycles.
path
Syntax path path-name
no path path-name
Context config>router>gmpls
Description This command creates the path to be used for a GMPLS LSP. A path can be used by multiple GMPLS
LSPs. A path can specify some or all hops from ingress to egress and they can be either strict or loose.
Empty paths are not supported for GMPLS LSPs.
Paths are created in a no shutdown state. A path must be shut down before making any changes
(adding or deleting hops) to the path. When a path is shut down, any GMPLS LSP using the path
becomes operationally down.
The no form of this command deletes the path and all its associated configuration information. All the
GMPLS LSPs that are currently using this path will be affected. A path must be shut down and
unbound from all GMPLS LSPs using the path before it can be deleted. The no path path-name
command will not result in any action except a warning message on the console indicating that the
path may be in use.
Parameters
path-name — Specifies a unique case-sensitive name label for the LSP path.
7450 ESS MPLS Guide
Values 32 characters maximum alphanumeric string
GMPLS
Page 479