Alcatel-Lucent 7450 Manual page 784

Show Commands
Output LDP Targeted Peer Output — The following table describes LDP targeted peer output.
Page 784
Label
Peer
Adm
Opr
Hello Factor
Hold Time
KA Factor
KA Timeout
Auth
Passive Mode
Auto Create
No. of Peers
Tunneling
The IP address of the peer.
Up — The LDP is administratively enabled.
Down — The LDP is administratively disabled.
Up — The LDP is operationally enabled.
Down — The LDP is operationally disabled.
The value by which the hello timeout should be divided to give the
hello time, for example, the time interval, in seconds, between LDP
hello messages. LDP uses hello messages to discover neighbors and to
detect loss of connectivity with its neighbors.
The hello time or hold time. The time interval, in seconds, that LDP
waits before declaring a neighbor to be down. Hello timeout is local to
the system and is sent in the hello messages to a neighbor.
The value by which the keepalive timeout should be divided to give the
keepalive time, for example, the time interval, in seconds,
between LDP keepalive messages. LDP keepalive messages are sent to
keep the LDP session from timing out when no other LDP traffic is
being sent between the neighbors.
The time interval, in seconds, that LDP waits before tearing down a
session. If no LDP messages are exchanged during this time interval,
the LDP session is torn down. Generally the value is configured to be 3
times the keepalive time (the time interval between successive LDP
keepalive messages).
Enabled — Authentication using MD5 message based digest proto-
col is enabled.
Disabled — No authentication is used.
The mode used to set up LDP sessions. This value is only applicable to
targeted sessions and not to LDP interfaces.
True — LDP responds only when it gets a connect request from a
peer and will not attempt to actively connect to its neighbors.
False — LDP actively tries to connect to its peers.
Specifies if a targeted peer was automatically created through service
manager. For an LDP interface, this value is always false.
The total number of LDP peers.
Enabled — Tunneling is enabled.
Disabled — No tunneling is used.
Description
7450 ESS MPLS Guide