Alcatel-Lucent 7450 Manual page 663

hello
Syntax hello timeout factor
no hello
Context config>router>ldp>if-params>interface>ipv4
config>router>ldp>if-params>interface>ipv6
config>router>ldp>if-params>ipv4
config>router>ldp>if-params>ipv6
config>router>ldp>targ-session>ipv4
config>router>ldp>targ-session>ipv6
config>router>ldp>targ-session>peer
config>router>ldp>targ-session>peer-template
Description This command configures the time interval to wait before declaring a neighbor down. The factor
parameter derives the hello interval.
Hold time is local to the system and sent in the hello messages to the neighbor. Hold time cannot be
less than three times the hello interval. The hold time can be configured globally (applies to all LDP
interfaces) or per interface. The most specific value is used.
When LDP session is being set up, the holddown time is negotiated to the lower of the two peers.
Once a operational value is agreed upon, the hello factor is used to derive the value of the hello
interval.
The no form of the command at the interface-parameters and targeted-session level sets the hello
timeout and the hello factor to the default values.
The no form of the command, at the interface level, will set the hello timeout and the hello factor to
the value defined under the interface-parameters level.
The no form of the command, at the peer level, will set the hello timeout and the hello factor to the
value defined under the targeted-session level.
Note that the session needs to be flapped for the new args to operate.
Default
Parameters
timeout — Configures the time interval, in seconds, that LDP waits before a neighbor down.
7450 ESS MPLS Guide
Context
config>router>ldp>if-params
config>router>ldp>targ-session
config>router>ldp>if-params>if
config>router>ldp>targ-session>peer
Values 1 — 65535
Interface Parameters Commands
Timeout
15
45
Inherits values from interface-parameters context.
Inherits values from targeted-session context.
Factor
3
3
Page 663