Alcatel-Lucent 7450 Manual page 255

working-tp-path
Syntax [no] working-tp-path
Context config>router>mpls>lsp
Description
This command creates or edits the working path for an MPLS-TP LSP. At least one working path (but
not more than one working path) must be created for an MPLS-TP LSP. If MPLS-TP linear protection
is also configured, then this is the path that is used as the default working path for the LSP, and it must
be created prior to the protect path. The working-tp-path can only be deleted if no protect-tp-path
exists for the LSP.
The following commands are applicable to the working-tp-path: lsp-num, in-label, out-label, mep,
shutdown.
Default
no working-tp-path
protect-tp-path
Syntax [no] protect-tp-path
Context config>router>mpls>lsp
Description This command creates or edits the protect path for an MPLS-TP LSP. At least one working path must
exist before a protect path can be created for an MPLS-TP LSP. If MPLS-TP linear protection is also
configured, then this is the path that is used as the default protect path for the LSP. The protect path
must be deleted before the wokring path. Only one protect path can be created for each MPLS-TP
LSP.
The following commands are applicable to the working-tp-path: lsp-num, in-label, out-label, mep,
shutdown.
lsp-num
Syntax lsp-num lsp-num
no lsp-num
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command configures the MPLS-TP LSP Number for the working TP path or the Protect TP
Path.
Default no lsp-num
Parameters
lsp-num — Specifies the LSP number.
7450 ESS MPLS Guide
Values 1 — 65535
Default 1 for a working path, 2 for a protect path
MPLS and RSVP
Page 255